x68000:how_to_open_x68000_compact
This is an old revision of the document!
How to open X68000 Compact
 | Remove the screws on the bottom → only one. |
 | Remove Slide the bottom part |
 | Remove the cover of the expansion board → use the driver again Since there is a nail → Remove the panel on the left when viewed from the front, remove the base there. |
 | I remove the panel on the right side. This ※ Remove the shield on the left to remove it towards the top and from the bottom → Remove the panel in the back, is OK at any timing. |
 | To detach twist as photo while pulling it back → |
 | Remove the panel at the top |
 | There are claws of two places in upper and disconnect it on the side of the nail down, is the front panel of the northeast. Please check with a photograph detent position, respectively. |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 | |
 |
x68000/how_to_open_x68000_compact.1407860740.txt.gz · Last modified: 2019/08/27 20:44 (external edit)