This is an old revision of the document!

How to open X68000 Compact

	Remove the screws on the bottom → only one.
	Remove Slide the bottom part
	Remove the cover of the expansion board → use the driver again Since there is a nail → Remove the panel on the left when viewed from the front, remove the base there.
	I remove the panel on the right side. This ※ Remove the shield on the left to remove it towards the top and from the bottom → Remove the panel in the back, is OK at any timing.
	To detach twist as photo while pulling it back →
	Remove the panel at the top
	There are claws of two places in upper and disconnect it on the side of the nail down, is the front panel of the northeast. Please check with a photograph detent position, respectively.


	It is easy to remove nails left when viewed from the front. Remove the nails so as to lift with a flathead screwdriver → this is located at the position of the button at the top right side of the nail, I pull on the front. Please put a force, making sure that the claws are out to ensure.

	It is a cinch the rest. I remove the white ring of 1. vinyl tape 2. plastic that holds the power cable.
	3.5 inches FDD
	I Remove the flat cable. I remove the cable side of the FDD. Pull over to after removing each receive an equal part of the nail sure that stopped four places in the claws of the plastic.
	If you do not remove the expansion box ※ carefully, bracket for board expansion ※ breaks the board unchecked? It does not come off that it is not removed from the body all the bracket. Pull over to after removing each receive an equal part of the nail sure that stopped four places in the claws of the plastic.