This is an old revision of the document!

How to open X68000 Compact

All info taken from http://x68k-retro.cocolog-nifty.com/blog/2008/04/x68000_compact__11fb.html

	Remove the screws on the bottom → only one.
	Remove Slide the bottom part
	Remove the cover of the expansion board → use the driver again Since there is a nail → Remove the panel on the left when viewed from the front, remove the base there.
	I remove the panel on the right side. This ※ Remove the shield on the left to remove it towards the top and from the bottom → Remove the panel in the back, is OK at any timing.
	To detach twist as photo while pulling it back →
	Remove the panel at the top
	There are claws of two places in upper and disconnect it on the side of the nail down, is the front panel of the northeast. Please check with a photograph detent position, respectively.


	It is easy to remove nails left when viewed from the front. Remove the nails so as to lift with a flathead screwdriver → this is located at the position of the button at the top right side of the nail, I pull on the front. Please put a force, making sure that the claws are out to ensure.

	It is a cinch the rest. I remove the white ring of 1. vinyl tape 2. plastic that holds the power cable.
	3.5 inches FDD
	I Remove the flat cable. I remove the cable side of the FDD. Pull over to after removing each receive an equal part of the nail sure that stopped four places in the claws of the plastic.
	If you do not remove the expansion box ※ carefully, bracket for board expansion ※ breaks the board unchecked? It does not come off that it is not removed from the body all the bracket. Pull over to after removing each receive an equal part of the nail sure that stopped four places in the claws of the plastic.

	It is the same manner as the FDD. If you are pulled to the top thrusting a hand in the expansion box is good in order to remove vertically.
	After you remove each receive an equal part of the nail sure that halted for two places in the claws of power plastic, I'll pull diagonally on.
	When the space can, I will disconnect the power connector that is connected to the main base. small nails It comes with the connector, I will be out even if not pulled with all his strength.
	cable of the speaker, so we hit the power supply fan section, Do not hook. Rear connector board (SCSI) So there is a (white) plastic nails in two places left and right and remove the flat cable, I will remove the nails

There are several places nails. First of all, please remove the claws of the position of the photo. |

	I will continue to slowly remove the base there after. It has become to be able to remove without bending the shield without use force, (sorry will be more ad lib here) Let's remove it calmly
	Speaker shield Once out, speaker terminal is visible.
	I will remove slowly or something pliers. You should remember where the enclosure cable speaker whether through before removing.
	And lower connector board (mouse keyboard joystick) (Easiest) to remove the nails of plastic (white) two positions I Remove the flat cable.

	You will work to remove the body of the main board from here Make sure the position (plastic? Vinyl? Still in place) of the claws turned over to the back side of the substrate. I will continue to remove the order from the white part of the nail.
	I will continue to remove the claws of the black part later. You remember well the wiring of the flat cable that is connected to the bottom connector board 1. Once ready to board floats. → I want to be easy to leave the flat cable 2.FDD, rear connector board (SCSI), which goes through the position has changed. If pulling as it is, you can remove the board.