Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
x68000:led_board [2011/02/09 08:50]
eidis
x68000:led_board [2019/08/27 20:45] (current)
Line 2: Line 2:
   ​   ​
 For this mod you'll require: For this mod you'll require:
-  ​ 
- * CF adapter with activity leds 
- 
- * Pin Header 
- 
- * Heat Shrink Sleeve 
  
- * A neat Black and Red cable pair (You can salvage them from old PC computer cases)+  *CF adapter with activity leds 
 +  *Pin Header 
 +  *Heat Shrink Sleeve 
 +  *A neat Black and Red cable pair (You can salvage them from old PC computer cases)
   ​   ​
 First of all desolder the HDD activity led and solder a pin header in its place. First of all desolder the HDD activity led and solder a pin header in its place.
   ​   ​
-{{ :​x68000:​led_mod_1.jpg }}+{{:​x68000:​led_mod_1.jpg|}}
   ​   ​
 If you want to be on the safe side, take a multimeter before soldering and measure the power output from the CF adapters HDD led activity headers. It should not be more than +2V. Then desolder the HD BUSY light diode which is a +2V diode  from the led panel and solder the wires to it. If you look carefully inside the light diode, you will see a small triangle which goes to one pin, and a bigger form which goes to the other pin. The bigger form is Ground, the small triangle pin is Positive. Prepare a small piece of heat shrink sleeve for each cable, solder the cable to the light diode and heat the heat shrink sleeve with soldering iron to make it shrink. The result should look similar to this. If you want to be on the safe side, take a multimeter before soldering and measure the power output from the CF adapters HDD led activity headers. It should not be more than +2V. Then desolder the HD BUSY light diode which is a +2V diode  from the led panel and solder the wires to it. If you look carefully inside the light diode, you will see a small triangle which goes to one pin, and a bigger form which goes to the other pin. The bigger form is Ground, the small triangle pin is Positive. Prepare a small piece of heat shrink sleeve for each cable, solder the cable to the light diode and heat the heat shrink sleeve with soldering iron to make it shrink. The result should look similar to this.
   ​   ​
-{{ :​x68000:​led_mod_2.jpg }}+{{:​x68000:​led_mod_2.jpg|}}
   ​   ​
 When all is finished, reassemble the led board. When all is finished, reassemble the led board.
   ​   ​
-{{ :​x68000:​led_mod_3.jpg }}+{{:​x68000:​led_mod_3.jpg|}}
  
    
 
 x68000/led_board.txt · Last modified: 2019/08/27 20:45 (external edit)
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Driven by DokuWiki